By Using The Air We Breathe
REACTR™
Removes Foul Water Odor, Taste and Stains
REACTR™ Water Treatment Systems
represent an advanced innovation in the treatment of water using a natural aeration process that...

• Improves bad taste, odor and color

• Eliminates sediment problems

• Stops red iron stains & sulfur odor

All without the use of chemicals!

Air efficiently mixes with water and permits iron particles to be trapped and sulfur smell to be exhausted. You get clear water that tastes and smells fresh!
Put Your Extra Pump Energy to Work

• Easy Installation and Maintenance

•Reduced Installation Errors

•Increased Air Draw and Mixing

•Diminished Diffuser Plugging

•Continuous Rinsing Of The Tank

•Decreased Water Line Plugging

•Less Back Pressure On The Nozzle

•Corrosion-Proof Air Check Valve

The REACTR™ design defines efficiency.
The aeration tank has a full 1" opening for
installation before the pressure tank. A
well pump exerts its full energy potential
to push water and pull air to naturally
treat foul tasting and smelling water.

An ingenious manifold design on
the top of the REACTR™
tank combines air injection into
the water and free air venting of
excess pressure and foul odors.
These innovations provide
advantages competing aeration
systems can't match.

Once the contaminants have thoroughly oxidized they can be trapped by the REACTR™ Filter filled with REACTR™ Blend Media. REACTR™ Blend is a proportioned mix of three proven filter medias. They provide a spectrum of filtering capabilities for a wide range of water problems.
Typical REACTR™ Installation
Air check valve is non-corrosive for years of service Air vent for the
releasing of
excess free air
Pressure tank stores
water and builds pressure
for the water service lines
Optional cleaning port or pressure gauge
Electrical Outlet
Chlorine feed port for use with the optional Oxy-Clean pump for cleaning the system

Recommended pressure relief valve

REACTR Filter filled with special REACTR Blend Media traps the suspended iron and other water
contaminants
REACTR Aeration tank mixes air with water and converts the iron in the water into suspended iron
Drain line for backwashing the filter
Special aeration orbs help mix air and water
Drain
1" supply line from the well
Pump regulator Pressure gauge
The Ultimate REACTR™
The "UT" style REACTR™ is typically used where more contact time is needed. It requires less ceiling height than a standard REACTR™ tank and adds additional contact time for high iron, manganese and sulfur levels. By combining the features of the Signature Series™ control valve and the "UT" style REACTR™ you have the finest water treatment system on the market today!
Special Options For Special Problems
The REACTR™ is also available with an optional Oxy-Clean system that can clean your water supply system from the aeration tank through the filter. Chlorine is introduced at the aeration tank manifold and removed in the filter bed during backwashing. The lines and the pressure tank are cleaned without adding any chemicals to your drinking water. No other system on the market today can offer you this protection.
While the REACTR™ stops odor, iron stains and adjusts acid water, a softener might be required for certain hard water conditions. Your CSI dealer will be able to determine if your water requires a softener and recommend the proper equipment.
CSI Home / Controls / Water Treatment / Contact CSI / About CSI / Employment at CSI / Site Map